![]() ![]() The only thing I've mnaged so far is a loong "beep" when I unplug the 6-pin power conector to the graphics card. I press the reset buton of the mobo and turn the PC on. nothing, I unplug all the RAM, try to boot it up. I have enabled power on by PCI and PCI-E in the BIOS, there is. I can verify the magic packet is definitely reaching the machine so it is not a routing issue. I have tried using both (MAC addresses used are definitely correct). I pressed enter in the keyboard and some key combinations but no response, then I turnet it off and on, and for my surprise, it didin't even did the bios check, not a single beep was heard, so I unplug it from the power, wait 1~2 mins, and try to boot it again. P5Q-E E8400 4GB Corsair XMS Corsair HX 620W There are two LAN ports on this board, apparently one PCI and one PCI-E. Now this morning I boot him up, go to the shower and stuff, and after 15 mins when I'm back the screens are still in black (with no imput signal) and but al the fans and such of the computer working. ![]() Last night when I turned off my computer in vista, I accidentaly clicked "sleep" insted of "shut down", and so, my PC apprently turned off. So, my fellow overclockers, here's my problem: Rear panel I/O ports USB 2.0 ports quantity, 2 USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity, 4 Ethernet LAN (RJ-45) ports, 1 eSATA ports quantity, 2 PS/. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |